Full 25-point door and opener safety check with every visit - springs, cables, rollers, tracks, and your LiftMaster or Chamberlain opener included
You get a price before we start. It does not change when the truck arrives.
Before
After
Before
After
Before
AfterGarage Door Before & After in Arlington, TX
Talking about our work only gets you so far. Seeing a rusted track swapped for a straight one, or a sagging door paneled level again, says more than any claim we could print. Below are the jobs we see week in and week out across Arlington, from Northside to the neighborhoods off Cooper Street. Each one starts with a problem and a written price, and ends with a door that works like it should, with the photo record to prove it.
Recent Transformations
Broken Torsion Spring on a Clopay Door, North Arlington
A two-car door off Green Oaks Boulevard came down uneven and sat crooked in the tracks. The problem was a snapped torsion spring, the coil above the header that does the actual lifting, which had broken clean at the center. We replaced both springs as a matched pair, since the second was the same age and would have followed within weeks. The result is a door that lifts evenly off the floor with one hand on the release cord, not a door that drops if you lose your grip on the handle.
Garage Door Opener Logic Board Failure, Southeast Arlington
The opener in a Southeast Arlington home had power but wouldn’t respond to the wall button or any remote. The logic board, the brains that interpret the signal and tell the motor to move, had cooked after a series of power surges. We replaced the board, reprogrammed the remotes and keypad, and adjusted the travel limits so the door didn’t slam down hard or stop three inches short. Same motor, new brain, $220 to $310 for this repair, and the customer kept their original LiftMaster.
Crescent Wrench and a Prayer: Realigning a Wayne Dalton Door, Dalworthington Gardens
This one sticks with us. A Wayne Dalton door had been “adjusted” so many times by a previous handyman that the horizontal tracks flared out by a half-inch on one side, letting the rollers skip whenever the door passed the bend. We pulled the track back to spec, replaced the scored rollers with sealed-bearing units, and reset the spring tension to match the door’s actual weight. A door that used to sound like a train derailment now glides.
Frozen Cable and a Door Half-Up at 2 a.m., Central Arlington
A call came in at 2:14 in the morning: a Chamberlain door had snapped a cable and was stuck halfway between open and closed, with the homeowner’s car trapped inside. One of our techs arrived within the hour, clamped the door safely, replaced both cables, and reset the tension. By 3:40 the door was closed, locked, and the customer had a written photo record of the failed cable and the new parts. That’s what the 24/7 thing means, a live person answering and a named technician showing up.
Dented Bottom Panel on an Amarr Door, South Arlington
A South Arlington homeowner backed a trailer into the bottom panel of an Amarr door, leaving a crease deep enough to pull the weather seal away from the jamb. We ordered the panel in the same factory color, swapped it out, and rehung the door so the seams lined up. Total cost landed at $340 to $480 depending on panel size and finish, and the customer got a written quote before we ordered anything.
Full Door Replacement: Rusted Railback to a New Raynor, West Arlington
A West Arlington door had seen twenty years of Texas heat and humidity, and the steel had begun to delaminate at the bottom edge, leaving the garage open to insects and worse. We measured the opening, ordered a new Raynor steel door with the same track dimensions, and had it installed in a day. The customer’s garage went from looking abandoned to looking like the newest house on the street, and the written warranty is tied to the photo record we handed over at the end.
Want Results Like These?
Every job above, from the 2 a.m. cable to the full-door swap, was quoted in writing before we picked up a tool, and every customer left with the photos to prove what was found and what was fixed. If your door in Arlington is giving you trouble, call us at (682) 452-1782 and ask for Marcus. You’ll get a straight answer and a written price, no surprises.
Written by Marcus Deller, Owner at Servo Garage Doors Arlington, serving Arlington since 2015.